ACE Air Conditioning & Electrical fixes dead outlets, tripping breakers, flickering lights, chirping smoke detectors and the wiring to gates and docks. We are a licensed and insured Florida electrical contractor, and you get a flat-rate price before any work starts.

Some electrical problems cannot wait for a convenient appointment. Call (386) 668-8651 right away if you notice any of these:
Until the electrician arrives, switch off the breaker for that circuit if you can reach the panel safely, and unplug whatever was running. If you see smoke or flames, get everyone out and call 911 first. Emergency service is available, and calls after normal hours carry an after-hours dispatch fee.
Below is what our customers actually paid for residential electrical service calls and repairs completed from January 2023 to October 2026. The range is the middle half of those jobs, and the typical figure is the median.
| Job | Typical | Most paid | Jobs |
|---|---|---|---|
| Electrical service call and repair at home | $253 | $159 to $392 | 135 |
These are what our customers actually paid for completed jobs from January 2023 to October 2026. Your exact price is quoted before any work starts.
When an outlet goes dead, the cause is usually one of three things: a tripped GFCI somewhere else on the circuit, a loose wire at the outlet itself, or a worn-out device. Before you call, check the GFCI outlets in the kitchen, bathrooms, garage and outside, and press reset on any that has tripped. One GFCI often protects several ordinary outlets downstream, so a tripped one in the garage can be the reason a porch outlet is dead.
A GFCI that trips over and over is doing its job: it senses current leaking where it should not. Here that often means rain or condensation inside an outdoor outlet, a weather cover that no longer closes, or a pump, freezer or power tool with a fault. We track down the source instead of swapping the outlet and hoping. GFCIs also wear out, and an old one may fail to trip when it should, which is the more dangerous failure.
Switches and dimmers fail in their own ways. A switch that feels loose, crackles or runs warm needs replacing. A dimmer that hums, or makes LED bulbs flicker, is often the wrong type for those bulbs, and an LED-rated dimmer usually cures it. We also fix three-way switches that stopped working together and add switches where a room never had one.

One flickering fixture usually points to a loose bulb, a failing LED driver, a worn socket or a loose wire in the box. Lights that dim or flicker across the whole house, especially when the AC or another big appliance starts, point to something bigger: a loose connection at the panel, the meter or the service wires. That kind of flicker needs an electrician soon, because loose connections heat up.
Breakers trip for a reason. The common ones are too much load on one circuit (a microwave and a toaster oven sharing a kitchen circuit, for example), a short in a cord or appliance, a ground fault on an outdoor circuit, or a breaker that has simply worn out. Resetting it again and again fixes nothing. We trace the circuit, test the breaker, and tell you whether the answer is a repair, a dedicated circuit for the appliance, or a new breaker. If the panel itself is the problem, our panel upgrade and rewiring page covers the options.
A chirp every minute or so usually means a low battery. If it keeps chirping after a fresh one, the detector may have reached the end of its life. Every smoke alarm has a manufacture date printed on the back, and its maker states how long it lasts. Once it is past that, replace it.
Many homes have hardwired detectors that are linked, so when one sounds they all sound. In those homes a single failing unit can wake the whole house in the middle of the night with no smoke anywhere. We find the one causing it, replace detectors with compatible models so the link keeps working, and test the full set when we are done. We also restore detectors that lost power to a tripped breaker or a loose connection, and add new ones when a remodel creates a bedroom that needs coverage.

Grounding gives stray current a safe path into the earth. Bonding ties metal parts together so they sit at the same voltage. When either one is loose, cut or corroded, you may feel a mild shock from an appliance or faucet, lose electronics to surges, or have GFCIs that misbehave. We test the ground rod connection, the grounding conductor and the water pipe bond, and repair whatever has failed.
Pools and spas rely on bonding more than any other part of a home. If anyone feels a tingle in the pool, the spa or on the deck, get everyone out of the water, keep them out, and call (386) 668-8651 right away.
Automatic gates and docks sit in sun and rain, so their wiring takes a beating. On gates we repair the buried feed, the outlet or disconnect at the operator, and the breaker trips caused by water in a box. If the fault is inside the gate operator itself, we will tell you, so you can call the gate company. Dock lights, outlets and boat lifts need GFCI protection and connections sealed against water. Nobody should swim near a dock that has given anyone a tingle until its power is off and the wiring has been repaired.
Call (386) 668-8651 or schedule online. The electrician finds the cause, explains it in plain words, and gives you a flat-rate price before any work starts, so you decide with the number in front of you.
Small like-for-like repairs, such as replacing an outlet, switch or breaker, often need no permit. When a repair grows into new wiring or a panel change, a licensed electrician pulls the permit and the local building department inspects the work. Our state licenses are listed on the licenses page.
ACE Air Conditioning & Electrical has been family-owned and operated since 1979. From January 2023 to October 2026 we completed 209 electrical jobs in DeBary, 153 in Deltona and 95 in Orange City.
Adding something new, like a generator or EV charger? See electrical installation. Buying a home, or has your insurer asked about the wiring? See electrical inspections.
A GFCI trips when it senses current leaking out of the circuit, which is a real hazard near water. Common causes are rain or condensation inside an outdoor outlet, a damaged extension cord, or a pool pump or appliance with a fault. Old GFCIs can also start tripping on their own. Unplug everything on the circuit and reset it. If it holds, add items back one at a time. If it trips with nothing plugged in, call us.
Look for a tripped GFCI first. One GFCI in a bathroom, the garage or outside often feeds outlets in other rooms, and pressing its reset button brings them back. If every GFCI is set and the outlets are still dead, the likely cause is a loose or burned connection in one of the outlets on that run. Leave it alone and have an electrician open it up, because loose connections get hot.
A single light that flickers is usually a bulb, a dimmer that does not suit LED bulbs, or a worn socket, and it is rarely urgent. Flickering or dimming in several rooms at once is different. It can mean a loose connection at the panel, the meter or the service wires, and loose connections build heat. Call us soon, and right away if you also notice a burning smell or a warm panel.
Check the date printed on the back of the detector. Once a smoke alarm passes the service life its maker lists, it may chirp to tell you it needs replacing, and a new battery will not stop it. A chirp can also come from the wrong battery type, a battery door that is not fully closed, or dust in the sensor. In a hardwired, linked system the chirping unit may not be the faulty one, so we test each detector.
From January 2023 to October 2026, our customers paid a typical $253 for a residential electrical service call and repair, and the middle half of those 135 jobs fell between $159 and $392. Your price depends on what the electrician finds. Either way, you get a flat-rate price before any work starts, and you decide whether to go ahead.
Yes. Emergency service is available, and after-hours calls carry an after-hours dispatch fee. Use it for real hazards: a burning smell, a hot outlet or panel, sparking, or a breaker that will not reset. Turn off the affected circuit if you can do it safely and call (386) 668-8651. If there is smoke or fire, get out of the house and call 911 before you call us.
Yes. We repair the electrical side of gates, docks and boat lifts: the underground feed, outlets, disconnects, GFCI protection, dock lights and the breakers that serve them. Water is the usual culprit, so we look for flooded boxes and corroded connections first. If the fault turns out to be inside the gate operator or the lift motor, we say so plainly, and you can call the company that services it. If anyone feels a tingle near a dock, keep everyone out of the water.
Service areas: DeBary, Deltona, Orange City, DeLand, Sanford, Lake Mary, and the rest of Volusia and Seminole counties. Call (386) 668-8651 or book online.

Rely on our skilled team for quick, reliable repairs that restore your comfort. We address issues promptly to minimize disruption—act now and experience seamless, efficient solutions today!